This is a pattern for a jacket / parka of moderate volume with a straight silhouette. The front panels feature separate yokes, with darts located in the yoke seams. In the lower part of the jacket, there are welt pockets with welts and flaps fastened with snaps. The sleeves are voluminous and two-seam, with a slightly dropped shoulder line. A drawstring casing is located at the waistline. The collar is a stand collar. The jacket / parka has a detachable hood, attached via a zipper; the zipper is concealed by a placket. The hood is of moderate volume and features a drawstring casing for adjusting the fit. The garment has a center front zipper closure. The zipper is covered by a wide windproof attached placket with snap fastening. The jacket is fully lined. The length is below hip level. The bottom edge of the jacket is shaped with a slight reduction in length at the sides.

TOTAL EASE ALLOWANCE, cm:

LENGTH, cm:

RECOMMENDED FABRICS:

For sewing this model, it is recommended to choose materials from the rain-coat group, from lightweight to dense. The materials may have water-repellent and windproof properties. By fiber composition, the material may contain natural (cotton) or blended fibers. Rain-coat gabardine, softshell, and duspo are well suited.

The jacket in the Elenapatternstudio photo is made of three-layer softshell on fleece, composition: membrane, fleece, polyester, spandex; density 320 g/m2. Lining – lining twill, 100% polyester, density 70 g/m2.

YOU WILL NEED:

• Main fabric, taking into account a 10% allowance for possible shrinkage, m:

Non-directional cutting, width 150 cm

• Lining fabric, taking into account a 10% allowance for possible shrinkage, m:

Non-directional cutting, width 140 cm

• Interfacing with a density of 30-40 g/m2 ~ 1 m at a width of 140 cm. For softshell, use low-temperature interfacing.
• Straight-grain fusible stay tape 10-15 mm wide ~ 2 m
• Stitched bias-cut fusible stay tape with stitch reinforcement 12-15 mm wide ~ 2 m
• Snaps 15 mm in diameter – 9 pcs.
• Eyelets 9-10 mm in diameter – 4 pcs.
• Coil (spiral) zipper T7, open-end, for the center fastening, may have two sliders, cm:

• Coil (spiral) zipper T5, open-end, for the hood attachment, 40 cm long – 1 pc.
• Garment cord 8 mm in diameter and 170 cm long – 1 pc.
• Garment cord 8 mm in diameter and 130 cm long for the hood – 1 pc.
• Threads to match the main fabric and to match the lining for the sewing machine.
• Universal or Microtex sewing machine needles No. 80-90.
• Needles No. 70 – 80 (preferably Microtex) for the lining.

 

NECESSARY EQUIPMENT:

• Sewing machine.
• Iron with steam function.
• Pressing table or ironing board.
• Special sewing machine foot for zippers.
• Press for installing eyelets and snaps.